Fern Wifi Er Ubuntu 18.04 Password By Attacking

Get A Wordlist Brute force attacks run down a wordlist, testing each possibility.

Use Aircrack-ng To Test Your WiFi Password on Kali Linux Details Nick Congleton Kali Linux 27 September 2018 Contents 1.

Objective 2. Distributions 3.

Conventions 6. Introduction 7.

Install Aircrack-ng 8.

Get A Wordlist 11.

Fern Wifi Er Ubuntu 18.04 Password By Attacking

Attack 12. Closing Thoughts Objective Test the security of your WiFi password by attacking it Distributions This will work with any Linux distribution, but its recommended that you use Kali.

Requirements A working Linux distribution with a WiFi adapter and root privileges.

Difficulty Easy Conventions - requires given linux commands to be executed with root privileges either directly as a root user or by use of sudo command - requires given linux commands to be executed as a regular non-privileged user Introduction Most people have terrible passwords, and WiFi is no exception.

Your WiFi password is your primary line of defense against unwanted access to your network.

That access can result in a whole host of other nasty things because an attacker can monitor the traffic on your network and even gain direct access to your computers.

The best way to prevent such an intrusion is to use the same tools an attacker would to test the security of your WiFi password.

Install Aircrack-ng This guide is going to use the Aircrack suite of tools.

Theyre already installed on Kali, so you wont have to do anything.

LOCATION: Fairbanks, Alaska, USA APPLY NOW Scan For Your Network First, find out what the name of your wireless interface is with ip a.

Once you have it, you can use airmon-ng to create a virtual monitoring interface on it.

Dump the results of the monitor into a terminal, so you can see them.

Dump The Results To A File Next, youre going to log the results of a scan to a file.

That capture log will be needed by Aircrack to run a brute force attack on the network later.

To get your capture, youre going to run the same command as before, but youll specify your BSSID, channel, and the log location.

Youre going to use this one to disconnect one of the clients on your network.

Take a look at the lower table in your other window running airodump-ng.

It contains the BSSID of your network along with the BSSIDs of the clients.

Pick one, and use the following linux command with that information.

That command will run indefinitely, continuously disconnecting that client.

In the first line of the airodump-ng window, look for a message concerning a handshake to appear at the end of the line.

Itll be harder to see if you had to run --ignore-negative-one because a message about that will occupy the same space, causing the handshake message to flash for a second before being overwritten.

After only a couple of minutes, you can safely stop the disconnect requests and the dump.

Install Fern Wifi Cracker Ubuntu 18.04